Send Message
Home News

Application and Using of Metallographic Cutting Machine

China Dongguan Quality Control Technology Co., Ltd. certification
China Dongguan Quality Control Technology Co., Ltd. certification
Customer Reviews
The touch screen micro vickers hardness tester has been installed a few weeks ago, everything is OK. Thanks for your advice and excellent service.

—— Mr. David Chambers

Thanks for the fast delivery and our customer is very satisfied for the rockwell hardness tester, and hope more orders soon.

—— Neil Renato

After we visited the customer, they finally decided to purchase Brinell hardness tester iBrin-413Z, now we have installed the unit at customer’s site,

—— Fermin Lee

Thank you for the indenters (diamond  cone 120 degrees). We recently got it and already tested it. Indenters  are good as we expected. 

—— Dalius Skinulis

The Measurements are good for Brinell Tester HBST-3000.

—— Sun Chull Kim

Hey, the hardness tester iVick-484ST was installed last week and works well, thanks for the professional support.

—— Sabinian Smith

I am glad to inform you that the installation of the SHB-3000C Brinell hardness tester has been finished successfully. I would like to thank you!

—— Robbin

I'm Online Chat Now
Company News
Application and Using of Metallographic Cutting Machine
Latest company news about Application and Using of Metallographic Cutting Machine


Application and Using of Metallographic Cutting Machine


The metallographic cutting machine is a commonly used equipment in metallographic laboratories for cutting and sampling metal materials. It is mainly used in metallographic microstructure analysis, quality control of metal materials, and scientific research.


The use of the metallographic cutting machine is as follows:


1. Preparation: Ensure the safety of the working area and wear personal protective equipment such as goggles, protective gloves and protective clothing.


2. Sample preparation: Clean the metal sample to be cut to remove dirt and oxides on the surface. Ensure that the surface of the sample is flat to obtain accurate cutting results.


3. Cutting parameter setting: Set appropriate cutting parameters according to the material and size of the sample. Mainly include parameters such as cutting speed, cutting depth and knife disk rotation speed. The selection of these parameters should be based on experience or reference to relevant experimental methods.


4. Adjust the cutting position: Place the sample on the cutting table, fix the part to be cut under the cutting knife by adjusting the clamping device and positioning device, and ensure the cutting position is accurate.


5. Start the cutting machine: Start the cutting machine according to the requirements of the equipment operation manual. Depending on the needs, you can choose manual operation or automatic operation mode.


6. Cutting: After starting cutting, the cutting disc will move along the preset path and gradually penetrate the metal sample during the cutting process. Pay attention to the situation during the cutting process to ensure the quality and safety of the cutting.


7. End of cutting: After the cutting is completed, stop the operation of the cutting machine. Carefully remove the cut sample to avoid injury. Clean the work area and remove the waste and debris generated by the cutting.


8. Sample processing: Clean the cut sample and perform further processing as needed, such as grinding, polishing, corrosion, etc., to obtain the required metallographic microstructure.


It should be noted that when using the metallographic cutting machine, the user should strictly abide by the relevant safety regulations and operating procedures to ensure personal safety and normal operation of the equipment.


Pub Time : 2024-06-11 07:47:53 >> News list
Contact Details
Dongguan Quality Control Technology Co., Ltd.

Contact Person: Mr. Raymond Chung

Tel: 86-13711988687

Fax: 86-769-22784276

Send your inquiry directly to us (0 / 3000)